Kerberos Commands - Lantronix SLC 8000 User Manual

Date/Time
Reboot & Shutdown
Local Users
Remote
Authentication
SSH Keys
User Menus
Web Access
Diagnostics &
Reports
Firmware &
Configuration
Internal Modem
Device Port
Operations
Device Port
Configuration
USB
SD Card
5. Click the Apply button.
Note: You must reboot the unit before your changes will take effect.

Kerberos Commands

These commands for the command line interface correspond to the web page entries described
above.
To configure the SLC unit to use Kerberos to authenticate users who log in via the Web,
SSH, Telnet, or the console port:
set kerberos <one or more parameters>
Parameters
breakseq <1-10 Chars>
clearports <Port List>
dataports <Port List>
escapeseq <1-10 Chars>
ipaddr <Key Distribution Center IP Address>
kdc <Key Distribution Center>
listenports <Port List>
port <Key Distribution Center TCP Port>
realm <Kerberos Realm>
state <enable|disable>
useldapforlookup <enable|disable>
To set user group and permissions for Kerberos users:
set kerberos group <default|power|admin>
SLC™ 8000 Advanced Console Manager User Guide
Right to set the date and time.
Right to shut down and reboot the SLC unit.
Right to add or delete local users on the system.
Right to assign a remote user to a user group and assign a set of rights to the user.
Right to set SSH keys for authenticating users.
Right to create a custom user menu for the CLI for LDAP users.
Right to access Web-Manager.
Right to obtain diagnostic information and reports about the unit.
Right to upgrade the firmware on the unit and save or restore a configuration (all
settings). Selecting this option automatically selects Reboot & Shutdown.
Right to update internal modem settings.
Right to control device ports.
Right to enter device port settings.
Right to enter modem settings for USB devices and control USB storage devices.
Right to enter settings for SD card.
11: User Authentication
204