Audit Log; Smtp; Ssh - Lantronix SLC 8000 User Manual

Info: Saves informative message, in addition to warning and error messages.

Debug: Saves extraneous detail that may be helpful in tracking down a problem, in addition to

information, warning, and error messages.
Network Level
Services
Authentication
Device Ports
Diagnostics
General
Remote Servers
(#1 and #2)

Audit Log

Enable Log
Size
Include CLI
Commands
Include In System
Log

SMTP

Server
Sender

SSH

Enable Logins
Web SSH
Timeout
SLC™ 8000 Advanced Console Manager User Guide
Messages concerning the network activity, for example about Ethernet and routing.
Messages concerning services such as SNMP and SMTP.
Messages concerning user authentication.
Messages concerning device ports and connections.
Messages concerning system status and problems.
Any message not in the categories above.
IP address of the remote server(s) where system logs are stored.
The system log is always saved to local SLC storage. It is retained through SLC unit
reboots for files up to 200K. Saving the system log to a server that supports remote
logging services (see RFC 3164) allows the administrator to save the complete system
log history.
Select to save a history of all configuration changes in a circular log. Disabled by
default. The audit log is saved through SLC 8000 advanced console manager reboots.
The log has a default maximum size of 50 Kbytes (approximately 500 entries). You
can set the maximum size of the log from 1 to 500 Kbytes.
Select to cause the audit log to include the CLI commands that have been executed.
Disabled by default.
If enabled, the contents of the audit log are added to the system log (under the
General/Info category/level). Disabled by default.
IP address of your network's Simple Mail Transfer Protocol (SMTP) relay server. If an
SMTP server is not specified, the SLC module will attempt to look up the MX record for
the domain in the destination email addresses of outgoing emails.
The email address of the sender of outgoing emails. The strings "$host" and "$domain"
can be part of the email address - they will be substituted with the actual hostname and
domain. The default is donotreply@$host.$domain.
Enables or disables SSH logins to the SLC unit to allow users to access the CLI using
SSH. Enabled by default.
This setting does not control SSH access to individual device ports. (See
- Settings (on page 105) for information on enabling SSH access to individual ports.)
Most system administrators enable SSH logins, which is the preferred method of
accessing the system.
Enables or disables the ability to access the SLC command Iine interface or device
ports (connect direct) through the Web SSH window. Disabled by default.
If you enable SSH logins, you can cause an idle connection to disconnect after a
specified number of minutes. Select Yes and enter a value of from 1 to 30 minutes.
7: Services
Device Ports
77