Kerberos Commands - Lantronix SLC8 User Manual

Remote
Authentication
SSH Keys
User Menus
Web Access
Diagnostics &
Reports
Reboot & Shutdown
Firmware &
Configuration
Device Port
Operations
Device Port
Configuration
USB
PC Card
5. Click the Apply button.
Note: You must reboot the unit before your changes will take effect.

Kerberos Commands

These commands for the command line interface correspond to the web page entries described
above.
To configure the SLC unit to use Kerberos to authenticate users who log in via the Web,
SSH, Telnet, or the console port:
set kerberos <one or more parameters>
Parameters:
accessoutlets <Outlet List>
breakseq <1-10 Chars>
clearports <Port List>
dataports <Port List>
escapeseq <1-10 Chars>
ipaddr <Key Distribution Center IP Address>
kdc <Key Distribution Center>
listenports <Port List>
port <Key Distribution Center TCP Port>
realm <Kerberos Realm>
state <enable|disable>
useldapforlookup <enable|disable>
To set user group and permissions for Kerberos users:
set kerberos group <default|power|admin>
SLC™ Console Manager User Guide
Right to assign a remote user to a user group and assign a set of rights to the user.
Right to set SSH keys for authenticating users.
Right to create a custom user menu for the CLI for Kerberos users.
Right to access Web-Manager.
Right to obtain diagnostic information and reports about the unit.
Right to use the CLI or shut down the SLC console manager and then reboot it.
Right to upgrade the firmware on the unit and save or restore a configuration (all
settings). Selecting this option automatically selects Reboot & Shutdown.
Right to control device ports.
Right to access to port settings.
Right to enter modem settings for USB devices. The USB checkbox is available for
certain SLC and SLB models.
Right to enter modem settings for PC cards. Includes managing storage PC cards.
The PC card checkbox is available for certain SLC and SLB models.
12: User Authentication
193