Connect The Lamp Power Supply (Lps) - Christie CP2230 Setup Manual

2.14 Connect the Lamp Power Supply (LPS)

WARNING
• You must connect the LPS to the cinema projector before you connect it to AC power.
• Certified electrician required. Ground (earth) connection is necessary for safety. Never com-
promise safety by returning the current through the ground. Connect ground FIRST to
reduce shock hazard from high leakage.
• Use an appropriate strain relief connector on the AC supply cable to prevent the cable from
rubbing against the LPS knockout plate and becoming damaged.
As shipped
200V 400V
Power Connectors (optional)
Must terminate the power connector terminal
block correctly to ensure 200VAC-240VAC
output. Line cord provided for connection
to projector only.
Power Connector Breaker
(On = up position)
1. Connect LPS Communication Cables:
a. Remove the 2 cover plate (2 thumbscrews) from the cinema projector's baseplate in the LVPS com-
partment.
b. Connect one end of the RS-232 cable to the port labeled RS232. Route the cable up through the open-
ing in the cinema projector's baseplate into the LVPS compartment. Connect the other end of the RS-
232 cable to the port labeled RS232 in the LVPS compartment.
c. Connect one end of the Interlock cable to the port on the LPS labeled Interlocks. Route the cable up
through the opening in the cinema projector's baseplate that you routed the RS-232 cable. Connect the
other end of the Interlock cable to the port labeled Interlock in the LVPS compartment.
CP2230 Setup Guide
020-100515-04 Rev. 1 (05-2014)
3
LPS Breaker
Phase Status LEDs
4.
Figure 2-15 Connect LPS
Configure the LPS for incoming AC
NOTE: Internal Input Line Voltage switch setting
must match AC available at the site.
Power Connector
Terminal Block
AC Input
Terminal Block
Earth Ground
Connect to 3-phase AC supply:
• 208 VAC in N. America
• 200 VAC in Japan
• 380-415 VAC in Europe
Line cord not supplied. Must supply
appropriate strain relief.
Installation and Setup
Interlocks
Connect communication
1
cables to projector
(inside LVPS compartment)
RS232
+ DC
Connect lamp leads
2
– DC
to projector (to igniter)
2-15