Specifying Settings For When Copying Is Finished Using The Adf (Mode 429) - Konica Minolta bizhub 362 User Manual

Utility mode
Specifying settings for when copying is finished using the ADF
(mode 429)
Specify whether or not all settings are reset when copying is finished using
the ADF.
Settings at time of purchase
Bit
Setting
Specifying the setting
During the production of this unit, the settings in the shaded cells were
selected. The numbers on the right side indicate the page numbers with
descriptions for the corresponding function.
Bit
7, 6
5
4, 3, 2, 1, 0
bizhub 362/282/222
7 6 5 4 3 2 1 0
0 0 0 0 0 1 0 0 (HEX: 04)
Description Setting
----------------------- 00
Specifies whether or 0
not all settings in the
Basics screen are
reset when copying
1
is finished using the
ADF.
----------------------- 00100
Description
*Do not change these bits
when specifying settings
for this function.
Does not perform the au-
tomatic panel reset oper-
ation
Performs the automatic
panel reset operation
Do not change these bits
when specifying settings
for this function.
11
Page Refer-
ence
----------
----------
----------
11-95