Specifying Administrator Forwarding Settings (Mode 198) - Konica Minolta bizhub 362 User Manual

11

Specifying administrator forwarding settings (mode 198)

You can specify whether a received document is forwarded to a destination
specified by the administrator.
Settings at time of purchase
Bit
Setting
Specifying the setting
The shaded cells represent the factory settings. The page numbers on the
right refer to the descriptions of the corresponding functions.
Bit
7
6
5, 4
3, 2, 1, 0
*
Bit 7 of mode 198 is enabled only when "1 (transmit)" is specified.
11-86
7 6 5 4 3 2 1 0
1 1 0 1 0 0 0 0 (HEX: D0)
Description Setting
Specifies whether a 0
received document
1
is forwarded to a
destination speci-
fied by the adminis-
trator.
Specifies whether to 0
enable TX Forward-
1
ing when scan-
ning.(*)
Specifies the print 00
conditions of trans-
01
mission reports for
TX Forwarding.(*)
10
11
----------------------- 0000
Description
Not forwarded
Forwarded
Not forwarded
Forwarded
Not ouput
Undeliverable
Always prints
*Do not specify this set-
ting for this function.
*Do not change these bits
when specifying settings
for this function.
bizhub 362/282/222
Utility mode
Page Refer-
ence
p. 11-53
----------
p. 11-53
----------