Specifying Settings For When Copying Is Finished Using The Adf (Mode 429); Specifying Settings To Limit The Use Of Communication Modes-1 (Mode 475) - Konica Minolta bizhub 362 User Manual

Utility mode
Specifying settings for when copying is finished using the ADF (mode
429)
Specify whether or not all settings are reset when copying is finished using
the ADF.
Settings at time of purchase
Bit
Setting
Specifying the setting
During the production of this unit, the settings in the shaded cells were se-
lected. The numbers on the right side indicate the page numbers with de-
scriptions for the corresponding function.
Bit
7, 6
5
4, 3, 2, 1, 0
Specifying settings to limit the use of communication modes–1 (mode
475)
Specify whether to permit or prohibit the use of individual communication
modes. Prohibited communication modes do not appear in their selection
screens.
Note
Programmed one-touch dial buttons can be used for transmission even
if a prohibited communication mode has been specified.
If all communication modes are prohibited (modes 475 to 477), some
screens, such as those for specifying transmission settings, may not nor-
mally be displayed.
362/350/282/250/222
7 6 5 4 3 2 1 0
0 0 0 0 0 1 0 0 (HEX: 04)
Description Setting
----------------------- 00
Specifies whether or 0
not all settings in the
Basics screen are
reset when copying
1
is finished using the
ADF.
----------------------- 00100
Description
*Do not change these bits
when specifying settings
for this function.
Does not perform the au-
tomatic panel reset oper-
ation
Performs the automatic
panel reset operation
*Do not change these bits
when specifying settings
for this function.
10
Page Refer-
ence
----------
----------
----------
10-95