Registering F-Code - Konica Minolta bizhub 362 User Manual

Registering/Settings
– To specify that the remainder of the transmission is for pulse
dialing, press [Tone]. "T" appears in the screen. If pulse dialing is
being used, press this button to send push-button tones.
– S: To perform a checked receiver transmission, touch [S] to type in
the special character "S". For details on checked receiver
transmissions, refer to "Checking the recipient before sending" on
page 3-32.
– To transmit overseas, press [Overseas].
When faxing overseas, depending on the destination, a
transmission error may occur if the transmission conditions are
poor. In this case, press [Overseas] to decrease the transmission
speed and allow the fax to be received more easily.
– To specify F-codes, press [F-CODE]. For details, refer to
"Registering F-CODE" on page 10-9.
– To specify the transmission speed, press [Speed]. For details, refer
to "Setting the Communication Speed" on page 10-11.
9
Check the information to be
registered, and then press [Enter].
– To change a setting, press the
button for the setting to be
changed, and then specify the
new setting.
? What does the three-digit
number beginning with "#" refer
to?
% The one-touch dial button number appears as a three-digit number
beginning with "#". A one-touch dial button number is specified for
each one-touch dial button. Instead of touching the one-touch dial
button, the recipient can be specified by pressing [#] key, then
entering the one-touch dial button number (between 000 and 539).
10
Press [Enter] in each screen until the standby screen (initial screen)
appears.
bizhub 362/282/222
10
10-7