Konica Minolta bizhub 362 User Manual page 73

Transmission
– S: To perform a checked receiver transmission, touch [S] to type in
the special character "S". For details on checked receiver
transmissions, refer to "Checking the recipient before sending" on
page 3-32.
When should [Pause] be used?
?
% When sending a fax to an outside line, press [Pause] after the
outside line access number (for example, "0") to ensure that a
connection is established.
% If a country code and recipient's fax number is entered immediately
after the international dialing code, a busy signal may heard while
the number is dialed and the fax cannot be sent. In this case, press
[Pause] twice after entering the international dialing code to enter a
six-second pause.
4
Place the original on the machine.
5
Press the [Start] key.
Scanning of the document begins, and then the fax is sent.
If multiple recipients were selected, the Dest. tab of the Check Job
Details screen appears so that the selected destinations can be
checked. For details, refer to "Transmitting to Multiple Destinations" on
page 3-28.
Note
To stop the transmission, press the [Stop] key. For details, refer to
"Stopping the transmission" on page 3-39.
If software switch settings were specified to limit dialing, a fax cannot be
sent by directly typing in the fax number. For details on the software
switch settings, refer to "Configuring Functions (Soft Switches)" on
page 11-67.
If software switch settings were specified to prevent broadcast
transmissions, a fax cannot be sent to multiple recipients. For details on
the software switch settings, refer to "Configuring Functions (Soft
Switches)" on page 11-67.
bizhub 362/282/222
3
3-21