Specifying Settings For Checked Receiver Trnasmission (Mode 200) - Konica Minolta bizhub 362 User Manual

Utility mode

Specifying settings for checked receiver trnasmission (mode 200)

Specify whether or not the fax transmission is sent after checking the CSI
(called subscriber ID) signal from the recipient's machine.
Settings at time of purchase
Bit
Setting
Specifying the setting
During the production of this unit, the settings in the shaded cells were
selected.
Bit
7, 6, 5
4
3, 2, 1, 0
bizhub 362/282/222
7 6 5 4 3 2 1 0
0 0 0 1 0 1 0 0 (HEX: 04)
Description Setting
----------------------- 000
Specify whether or 0
not the machine per-
forms a checked re-
ceiver transmission
1
if the called number
does not contain
special characters
for a checked re-
ceiver transmission.
Specifies the 0000
number of digits of
0001
the CSI signal that
are compared when
0010
performing a
checked receiver
0011
transmission.
(If the called number 0100
does not fulfill the
0101
number of digits
specified here, a
0110
comparison is made
with all digits of the
0111
called number. If a
comparison is made 1000
with a comparison
1001
number using spe-
cial characters, the
1010
comparison is made
with all digits of the
1011-1111
comparison
number, regardless
of the number of
digits specified with
this setting.)
Description
*Do not change these bits
when specifying settings
for this function.
Does not perform a
checked receiver trans-
mission
Performs a checked re-
ceiver transmission
Cancel
1 digit
2 digits
3 digits
4 digits
5 digits
6 digits
7 digits
8 digits
9 digits
10 digits
*Do not specify these set-
tings for this function.
11
Page Refer-
ence
----------
p. 3-32
p. 3-32
11-87