Utility mode
–
To specify settings for documents sent through the network (such
as Internet faxes), press [Network].
–
If software switch settings were specified to block faxes received
from senders other than those specified, only the setting for
"Network" can be specified. For details on the software switch
settings, refer to "Configuring Functions (Soft Switches)" on
page 11-67.
6
Select whether or not document
management is performed.
–
If document management is set
to "YES", specify the operation
performed on the received
document.
7
Specify how received documents are
handled.
–
Press [RX Doc. Settings], select
the operation to be performed,
and then press [Enter].
8
If "RX Doc. Settings" was set to
"Forward", specify a destination.
–
To add a new forwarding
destination, press [Next
Destination].
–
To view the details of the
forwarding destination, select the
destination, and then press
[Detail].
–
To delete a forwarding destination, select the destination, and then
press [Delete].
9
Press [Enter] in each screen until the standby screen (initial screen)
appears.
bizhub 362/282/222
11
11-57