Transmission applications
!
Detail
Transmission source information must be programmed in advance. For
details, refer to "Registering TSI Names" on page 11-27.
Whether or not transmission source information is printed can be
specified with the TX Settings parameters in Administrator mode. For
details, refer to "Specifying transmission settings (TX Settings)" on
page 11-33.
The settings specified for "TSI Selection" are reset after each
transmission.
The header information is printed as shown below, according to the selected
setting.
If only the "TSI" function was selected
The document can be sent with the name of the sender, the transmission
date and the document number added.
bizhub 362/282/222
7
7-9