Specifying management settings
Specifying administrator forwarding settings (mode 198)
You can specify whether a received document is forwarded to a destination
specified by the administrator.
Factory settings
Bit
Setting
Specifying settings
The shaded cells represent the factory settings. The page numbers on the
right refer to the descriptions of the corresponding functions.
Bit
7
6
5, 4
3, 2, 1, 0
(*)
Bit 7 of mode 198 is enabled only when "1 (transmit)" is specified.
bizhub 362/282/222
7 6 5 4 3 2 1 0
1 1 0 1 0 0 0 0 (HEX: D0)
Description
Specifies whether a received
document is forwarded to a
destination specified by the
administrator.
Specifies whether to enable
TX Forwarding when scan-
ning.(*)
Specifies the print condi-
tions of transmission reports
for TX Forwarding.(*)
-----------------------------
Setting
Description
0
Not forwarded
1
Forwarded
0
Not forwarded
1
Forwarded
00
Not output
01
Undeliverable
10
Always prints
11
*Do not specify these set-
tings.
0000
*Do not change these bits
when specifying settings for
this function.
10
Page Ref-
erence
page 10-2
0
---------
---------
---------
10-35