Front Door Window Frame Molding Removal; Installation; Headliner Removal - Chrysler 2004 Concorde Service Manual

LH
FLOOR CONSOLE (Continued)
1 - CONSOLE BRACKET
2 - FASTENERS
3 - FLOOR CONSOLE
FRONT DOOR WINDOW FRAME
MOLDING
REMOVAL
(1) Remove flag trim, speaker, door trim panel,
watershield as necessary, and mirror.
(2) Remove door glass run weatherstrip as neces-
sary to gain access to applique fasteners.
(3) Remove screws attaching molding to window
frame (Fig. 17).
(4) Remove molding from door.

INSTALLATION

(1) Place molding in position on door.
(2) Install screws attaching molding to window
frame.
(3) Install door glass run weatherstrip.
(4) Install the mirror, water shield, door trim
panel, speaker and flag trim.
HEADLINER
REMOVAL
(1) Remove front passenger seat for ease of
removal of headliner.
(2) Remove right and left A-pillar trim panels.
(3) Remove right and left sun visors. Do not
remove sun visor retainers at this time.
(4) Remove overhead console or front interior
lights.
Fig. 16 FLOOR CONSOLE
4 - FLOOR CONSOLE DUCT
5 - SHIFTER ASSEMBLY
Fig. 17 FRONT DOOR FRAME WINDOW
1 - REMOVE SCREWS
2 - LOOSEN HALFWAY
(5) Disconnect wire harness along A-pillar and
wire connector to the fuse panel.
(6) Remove upper B-pillar trim panels.
(7) Remove front and rear assist handles (if
equipped).
(8) Remove quarter trim upper panels partial,
keeping belt attached.
(9) Fully recline front seat.
(10) Remove right and left sun visor retainers.
INTERIOR 23 - 69