Chrysler 2004 Concorde Service Manual page 1459

LH
FRONT SEAT CUSHION COVER (Continued)
(1) Remove track and recliner assembly (Refer to
23 - BODY/SEATS/SEAT TRACK & RECLINER
ASSEMBLY - REMOVAL).
(2) Disconnect seat cushion heater element har-
ness connectors from seat pan.
(3) Remove seat back (Refer to 23 - BODY/SEATS/
FRONT SEAT BACK - REMOVAL).
(4) Disengage J-strap attaching seat cover from
the seat cushion frame (Fig. 23).
(5) Peel cover from foam and foam from frame
access the hog rings (Fig. 24).
(6) Cut hog rings attaching seat cover seat cush-
ion.
(7) Route seat function switches through access
hole on outboard side of seat cushion.
(8) Remove seat cushion cover from seat cushion.
Fig. 23 FRONT SEAT CUSHION J- STRAP
1 - J-STRAP
Fig. 24 SEAT CUSHION COVER
1 - SEAT COVER
2 - HOG RINGS
INSTALLATION - HEATED
(1) Position seat cover on cushion. Ensure to repo-
sition seat anti squeak sheet to frame, if equipped.
(2) Route seat function switches through access
hole on outboard side of seat cushion. (Fig. 25)
(3) Align seat cover with cushion alignment inden-
tations.
(4) Engage seat cushion heater element connector.
(5) Install hog rings.
(6) Engage J-strap attaching seat cover to front of
seat cushion frame.
(7) Install seat back (Refer to 23 - BODY/SEATS/
FRONT SEAT BACK - INSTALLATION).
(8) Connect seat cushion heater element harness
connectors from seat pan.
(9) Install track and recliner assembly (Refer to 23
- BODY/SEATS/SEAT
ASSEMBLY - INSTALLATION).
Fig. 25 SEAT CUSHION ALIGNMENT INDENTATIONS
1 - SEAT CUSHION
2 - ALIGNMENT INDENTATIONS
3 - HOOK AND LOOP FASTENER
SEATS 23 - 89
TRACK & RECLINER