Reservoir Description; Operation - Chrysler 2004 Concorde Service Manual

19 - 72 PUMP
HOSES (Continued)
(12) Align center take-off on steering gear with the
tie rod assemblies. Install tie rod attaching bolts and
washers into steering gear. Be sure washers are
installed between tie rods and steering gear
(Fig. 40). Tighten the tie rod-to-steering gear bolts to
a torque of 100 N·m (74 ft. lbs.).
CAUTION: After tie rod attaching bolts are torqued,
bend retaining plate tabs against heads of attaching
bolts (Fig. 30).
Fig. 40 Tie Rod Attachment
1 - RETAINING TABS
2 - BOLTS
3 - RETAINING PLATE
4 - STEERING GEAR
5 - WASHER
6 - TIE RODS
7 - WASHER
(13) Install the vacuum hose for the vacuum
booster on intake manifold vacuum port. Install hose
clamp on vacuum hose.
(14) Install the master cylinder on the vacuum
booster. Install the two nuts attaching the master
cylinder to the vacuum booster. Tighten the master
cylinder mounting nuts to a torque of 28 N·m (250 in.
lbs.).
(15) Remove the clamp from the steering wheel
(Fig. 28).
(16) Install the intermediate shaft onto the steer-
ing column shaft. Install steering column coupler
pinch bolt (Fig. 29) and tighten to a torque of 28 N·m
(21 ft. lbs.). Install the pinch bolt nut retaining pin in
pinch bolt.
(17) Install the cowl reinforcement on the vehicle
(Fig. 26). Install the eight bolts attaching the rein-
forcement to the strut towers. Install the bolt attach-
ing the wiper module to the reinforcement.
(18) Install the in-line resonator and inlet hose on
the throttle body and air let hose coming from the lid
of the air cleaner housing (Fig. 27).
(19) Install the covers over the wiper module and
the cowl (Fig. 25). Install and securely tighten the
attaching screws.
(20) Install the wiper arms on the pivots (Fig. 24).
Install and securely tighten the wiper arm to pivot
attaching nuts. Install the caps on the wiper arms
covering the pivot nuts.
(21) Install the battery ground cable onto the
ground stud on the shock tower.
(22) Perform Power Steering Pump Initial Opera-
tion procedure. (Refer to 19 - STEERING/PUMP -
STANDARD PROCEDURE)
(23) Lower vehicle.
(24) Adjust front toe as necessary. (Refer to 2 -
SUSPENSION/WHEEL ALIGNMENT - STANDARD
PROCEDURE)
RESERVOIR
DESCRIPTION
Vehicles equipped with the 2.7 liter engine use a
power steering pump that has an integral reservoir
(Fig. 1). Vehicles equipped with the 3.5 liter engine
use a power steering pump that has a remotely
mounted reservoir (Fig. 41).
Fig. 41 Power Steering Fluid Reservoir (3.5L
1 - SPEED CONTROL SERVO
2 - POWER STEERING FLUID RESERVOIR

OPERATION

The power steering fluid reservoir stores fluid for
the power steering system.
Engine)
LH