Installation; Shroud - Upper; Removal - Chrysler 2004 Concorde Service Manual

LH
SHROUD - LOWER (Continued)
(6) Remove the upper shroud from the steering col-
umn using the following procedure:
(a) On the right side of the steering column,
push in on seam between the upper and lower
shrouds at the forward end (near instrument
panel). The seam should snap open, releasing that
side of the upper shroud.
(b) Once the shroud unsnaps, pull that side of
the upper shroud upward away from the lower.
(c) Repeat this procedure on the opposite side of
the column, then remove the upper shroud.
(7) Remove the screw fastening the tilt lever to the
steering column (Fig. 46). Remove the lever.
Fig. 46 Tilt Lever, Upper And Lower Shrouds
1 - UPPER SHROUD
2 - TILT LEVER
3 - LOWER SHROUD
(8) Remove the two screws attaching the lower
shroud to the steering column. Remove the lower
shroud from the steering column.

INSTALLATION

(1) Install the lower shroud on the steering column
(Fig. 46). Install the 2 screws attaching the lower
shroud to the steering column.
(2) Install the tilt lever on the steering column and
install the mounting screw (Fig. 46).
(3) Install the upper shroud on the steering col-
umn by snapping it onto the lower shroud. Make
sure there are no gaps between the two shrouds once
the upper shroud is installed.
(4) Install the parking brake release cable on the
parking brake release handle in the lower instru-
ment panel cover (Fig. 45).
(5) Connect the wiring harness to the trunk
release switch in the lower instrument panel cover
(Fig. 44).
(6) Install the lower instrument panel cover using
the retaining clips along the top and right edge.
(7) Install the two screws behind the fuse panel
cover attaching the lower instrument panel cover to
the instrument panel (Fig. 43).
(8) Install the fuse panel cover on the left end of
the instrument panel (Fig. 42).

SHROUD - UPPER

REMOVAL

CAUTION: The upper shroud is retained to the
steering column by a snap fit to the lower shroud.
When removing the upper shroud from the lower
shroud, DO NOT use a hard or sharp tool. This will
damage the shrouds. If a tool must be used, use a
soft tool such as a trim stick.
(1) On the right side of the steering column, push
in on seam between the upper and lower shrouds at
the forward end (near instrument panel). The seam
should snap open, releasing that side of the upper
shroud.
(2) Once the shroud unsnaps, pull that side of the
upper shroud upward away from the lower.
(3) Repeat this procedure on the opposite side of
the column, then remove the upper shroud.
INSTALLATION
(1) Install the upper shroud on the steering col-
umn by snapping it onto the lower shroud.
(2) Make sure there are no gaps at the seam
between the two shrouds.
COLUMN 19 - 29