Seal - Oil Pump Removal; Shift Interlock Cable - Chrysler 2004 Concorde Service Manual

LH
SEAL - OIL PUMP
REMOVAL
The transaxle must be removed from the vehicle to
replace this oil seal.
(1) Remove the transaxle from the vehicle (Refer
to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC
- 42LE - REMOVAL).
(2) Remove the torque converter from the trans-
axle bellhousing.
(3) Use special tool C-3981B to remove oil pump
seal (Fig. 346).
Fig. 346 Oil Seal Removal
1 - SPECIAL TOOL C-3981B
2 - WRENCH
INSTALLATION
(1) Clean and inspect oil pump seal seat. Then
install seal using special tool C-4193A (Fig. 347).
Fig. 347 Oil Seal Installation
1 - TRANSAXLE BELL HOUSING
2 - SPECIAL TOOL C-4193A
3 - LONG STUB SHAFT
(2) Clean and inspect torque converter hub. If
nicks, scratches or hub wear are found, torque con-
verter replacement will be required.
CAUTION: If the torque converter is being replaced,
apply a light coating of grease to the crankshaft
pilot hole. Also inspect the engine drive plate for
cracks. If any cracks are found replace the drive
plate. Do not attempt to repair a cracked drive plate.
Always use new torque converter to drive plate
bolts.
(3) Apply a light film of transmission oil to the
torque converter hub and oil seal lips. Then install
torque converter into transaxle. Be sure that the hub
lugs mesh with the front pump lugs when installing.
(4) Reinstall the transaxle into the vehicle.

SHIFT INTERLOCK CABLE

REMOVAL
NOTE: Floor Shift Models
(1) Using suitable size allen wrench, remove the
gearshift knob retaining screw (Fig. 348).
Fig. 348 Shift Handle Retaining Screw
1 - GEARSHIFT KNOB
2 - HEX WRENCH
(2) Remove gearshift knob from shifter assy.
(3) Remove console bezel from vehicle.
TRANSAXLE 21 - 129