Chrysler 2004 Concorde Service Manual page 1386

23 - 16 DECKLID
LOCK CYLINDER (Continued)
(8) Adjust decklid latch for proper decklid to quar-
ter panel alignment and weatherstrip sealing.
(9) Install fasteners to attach decklid lining to rear
of decklid.
(10) Verify decklid latch operation.
EMERGENCY RELEASE CABLE
REMOVAL
(1) Remove the decklid cover. (Refer to 23 - BODY/
DECKLID/HATCH/LIFTGATE/TAILGATE/COVER -
REMOVAL)
(2) Unclip cable and handle assembly (Fig. 8).
Fig. 8 EMERGENCY RELEASE CABLE
1 - RELEASE CABLE CLIP
2 - DECKLID LATCH
INSTALLATION
(1) Clip emergency release cable onto the latch.
(2) Install the decklid cover. (Refer to 23 - BODY/
DECKLID/HATCH/LIFTGATE/TAILGATE/COVER -
INSTALLATION)
SLAM BUMPER
REMOVAL
(1) Open decklid.
(2) Pull slam bumper from decklid.
(3) Remove slam bumper from decklid.
INSTALLATION
(1) Place slam bumper in position on decklid.
(2) Push slam bumper into decklid.
(3) Verify decklid alignment.
SUPPORT CYLINDER
REMOVAL
(1) Open decklid.
(2) Support decklid with a suitable prop device.
(3) Remove gas prop lock caps on each end (Fig. 9).
(4) Remove gas prop from vehicle.
Fig. 9 DECKLID GAS PROP
1 - LOCK CAP
2 - DECKLID
3 - LOCK CAP
4 - GAS PROP
INSTALLATION
(1) Place gas prop in position on vehicle.
(2) Install the lock caps on the gas prop.
(3) Verify decklid operation.
LH