Chrysler 2004 Concorde Service Manual page 1458

Hide thumbs Also See for 2004 Concorde:
Table of Contents

Advertisement

23 - 88
SEATS
SEAT BACK PANEL (Continued)
INSTALLATION - AIRBAG EQUIPPED
CAUTION: Always install new push pins in the
upper mounting location of back panel. Failure to
do so could adversely affect the airbag system.
(1) Starting at the bottom, line up back panel
retaining tabs and new push pins. Then push sharply
to snap in place.
(2) Check back panel fit and finish. Run a finger
down the sides of back panel to be certain panel fits
tight to the rear of trim cover.
CAUTION: Be certain seat back panel is properly
secured in place. Failure to do so could adversely
affect the airbag system.
(3) Connect the negative battery cable.
FRONT SEAT CUSHION
REMOVAL
WARNING: DISCONNECT AND ISOLATE THE NEGA-
TIVE
BATTERY
CABLE
BEFORE BEGINNING ANY FRONT SEAT REMOVAL
OR INSTALLATION PROCEDURE. THIS WILL DIS-
ABLE THE AIRBAG SYSTEM. FAILURE TO DISCON-
NECT
THE
BATTERY
ACCIDENTAL AIRBAG DEPLOYMENT AND POSSI-
BLE PERSONAL INJURY.
WARNING: ONCE THE NEGATIVE CABLE IS DIS-
CONNECTED WAIT FOR 2 MINUTES BEFORE
REMOVING ANY AIRBAG SYSTEM COMPONENTS.
(1) Remove track and recliner assembly (Refer to
23 - BODY/SEATS/SEAT TRACK & RECLINER
ASSEMBLY - REMOVAL).
(2) Remove front seat back (Refer to 23 - BODY/
SEATS/FRONT SEAT BACK - REMOVAL).
(3) Disconnect seat cushion heater element connec-
tor, if equipped.
(4) Disconnect wire harness fasteners from cushion
frame (Fig. 21).
(5) Remove seat cushion (Fig. 22).
INSTALLATION
(1) Install wire harness fasteners to cushion frame
(Fig. 21).
(2) Connect seat cushion heater element connector,
if equipped.
(3) Install track and recliner assembly (Refer to 23
-
BODY/SEATS/SEAT
ASSEMBLY - INSTALLATION).
REMOTE
TERMINAL
COULD
RESULT
TRACK
&
RECLINER
Fig. 21 FRONT SEAT CUSHION WIRE HARNESS
1 - WIRE HARNESS
IN
Fig. 22 FRONT SEAT CUSHION
1 - FRONT SEAT CUSHION
(4) Install front seat back (Refer to 23 - BODY/
SEATS/FRONT SEAT BACK - INSTALLATION).
FRONT SEAT CUSHION COVER
REMOVAL - HEATED
WARNING: DISCONNECT AND ISOLATE THE NEGA-
TIVE
BATTERY
BEFORE BEGINNING ANY FRONT SEAT REMOVAL
OR INSTALLATION PROCEDURE. THIS WILL DIS-
ABLE THE AIRBAG SYSTEM. FAILURE TO DISCON-
NECT
THE
ACCIDENTAL AIRBAG DEPLOYMENT AND POSSI-
BLE PERSONAL INJURY.
WARNING: ONCE THE NEGATIVE CABLE IS DIS-
CONNECTED WAIT FOR 2 MINUTES BEFORE
REMOVING ANY AIRBAG SYSTEM COMPONENTS.
CABLE
REMOTE
BATTERY
COULD
LH
TERMINAL
RESULT
IN

Advertisement

Table of Contents
loading

This manual is also suitable for:

300m

Table of Contents