Installation; Engine Mounting Description - Chrysler 2004 Concorde Service Manual

LH
VIBRATION DAMPER (Continued)
(4) Remove the accessory drive belts. (Refer to 7 -
COOLING/ACCESSORY DRIVE/DRIVE BELTS -
REMOVAL)
(5) Use Special Tool 8191 to hold crankshaft
damper while removing center bolt (Fig. 95).
(6) Use Special Tool 1023 puller, and insert
C-4685-C2, remove crankshaft damper (Fig. 96).
Fig. 95 Crankshaft Damper Center Bolt - Removal
and Installation
1 - SPECIAL TOOL 8191
2 - CRANKSHAFT DAMPER
Fig. 96 CRANKSHAFT DAMPER - REMOVAL
1 - SPECIAL TOOL
1023
2 - SPECIAL TOOL
C-4685–C2
INSERT

INSTALLATION

(1) Install crankshaft damper using Special Tools
C-4685-C1 (5.9 in.) Bolt, with Nut and Thrust Bear-
ing from 6792, and 6792-1 Installer (Fig. 97). Install
center bolt and tighten to 115 N·m (85 ft. lbs.) (Fig.
95).
Fig. 97 CRANKSHAFT DAMPER - INSTALLATION
1 - SPECIAL TOOL
6792–1
2 - SPECIAL TOOL
C-4685–C1
(2) Install accessory drive belts. (Refer to 7 -
COOLING/ACCESSORY DRIVE/DRIVE BELTS -
INSTALLATION)
(3) Install radiator fan. (Refer to 7 - COOLING/
ENGINE/RADIATOR FAN - INSTALLATION)
(4) Install upper radiator crossmember. (Refer to
23 - BODY/EXTERIOR/GRILLE OPENING REIN-
FORCEMENT - INSTALLATION)
(5) Connect negative cable.
ENGINE MOUNTING
DESCRIPTION
The engine mounting system consist of three
mounts; two hydro-type mounts are attached to the
right and left side of the engine block, and one
molded rubber type rear mount is attached to the
transaxle (Fig. 99). All three mounts attach to the
suspension crossmember/engine cradle.
The engine hydro-type mounts contain a liquid
that is encased in a solid rubber housing.
ENGINE 9 - 57