Chrysler 2004 Concorde Service Manual page 1163

LH
BUSHING - INNER TIE ROD (Continued)
(9) Tighten both tie rod to steering gear bolts to a
torque of 100 N·m (74 ft. lbs.).
(10) Bend retaining tabs against heads of tie rod
attaching bolts (Fig. 57).
(11) Place the front wheels in the straight-ahead
position.
(12) Tighten the outer tie rod steering arm nut to
a torque of 37 N·m (27 ft. lbs.).
(13) Install the wheel and tire assembly. Install
and tighten wheel mounting stud nuts in proper
sequence until all nuts are torqued to half specifica-
tion. Then repeat the tightening sequence to the full
specified torque of 135 N·m (100 ft. lbs.).
(14) Lower the vehicle.
(15) Install the in-line resonator and inlet hose on
the throttle body and air inlet hose coming from the
lid of the air cleaner housing (Fig. 54).
(16) Install the reinforcement on the vehicle (Fig.
53). Install the eight bolts attaching the cowl rein-
forcement to the strut towers. Install the bolt attach-
ing the wiper module to the reinforcement.
(17) Install the covers over the wiper module and
the cowl (Fig. 52). Install and securely tighten the
attaching screws.
(18) Install the wiper arms on the pivots (Fig. 51).
Install and securely tighten the wiper arm to pivot
attaching nuts. Install the caps on the wiper arms
covering the pivot nuts.
(19) Install the battery ground cable onto the
ground stud on the shock tower and install nut.
(20) Adjust front toe. Refer to Wheel Alignment in
Suspension.
GEAR 19 - 57