Chrysler 2004 Concorde Service Manual page 1145

LH
GEAR (Continued)
(10) Remove the in-line resonator and inlet hose
(Fig. 9) from the throttle body and air let hose com-
ing from the lid of the air cleaner housing.
Fig. 9 In-Line Resonator And Air Inlet Hose
1 - AIR INLET HOSE
2 - THROTTLE BODY
3 - AIR INLET HOSE
4 - AIR CLEANER HOUSING LID
5 - RESONATOR
6 - IN-LINE RESONATOR
(11) If the steering gear being removed from the
vehicle is a speed proportional steering gear, discon-
nect the wiring harness connector from the solenoid
control valve electrical connector. The connector is
located on the steering gear end cap below the brake
master cylinder. (Fig. 10).
Fig. 10 Wiring Harness
1 - SPEED PROPORTIONAL STEERING SOLENOID CONNECTOR
2 - MASTER CYLINDER RESERVOIR
(12) Remove the two nuts mounting the master
cylinder to the vacuum booster (Fig. 11).
Fig. 11 Master Cylinder To Vacuum Booster Mounting
1 - MOUNTING NUT
2 - MASTER CYLINDER
3 - MOUNTING NUT
4 - VACUUM BOOSTER
(13) Disconnect the brake fluid level switch connector
on the side of the master cylinder fluid reservoir.
(14) Remove the master cylinder with the brake
tubes connected from the power brake vacuum booster.
Carefully position the master cylinder in an upright
position on the left side valve cover of the engine.
CAUTION: Do not allow brake fluid to leak onto
painted surfaces. Paint damage may occur.
(15) Remove the vacuum supply hose to the power
brake vacuum booster at the check valve in the vacuum
booster. Position the vacuum hose out of the way.
(16) Bend back the retaining tabs on the mounting
plate for the tie rod to steering gear mounting bolts
(Fig. 12).
Fig. 12 Tie Rod Attachment Bolt Retaining Tabs
1 - STEERING GEAR
2 - TIE RODS
3 - RETAINING TABS
4 - BOLTS
5 - PLATE
GEAR 19 - 39