Installation - Chrysler 2004 Concorde Service Manual

23 - 24 DOOR - FRONT
TRIM PANEL (Continued)
(8) Remove three screws in the speaker area.
NOTE: Door trim clips are reusable up to three
times, then should be replaced.
(9) Using a trim tool, disengage the two retainer
clips at rear of panel from the door trim panel to the
sheet metal inner panel.
(10) Raise trim panel up to disengage from the
belt being careful to hold the panel securely.
CAUTION: Failure to hold the door trim panel before
disengagement of the linkage will result in remote
handle damage.
(11) Disconnect the linkage from the remote han-
dle assembly (Fig. 16).
(12) Disconnect the power mirror switch.
(13) Disconnect the power door lock switch wire
connector.
(14) Disconnect the power window switch wire con-
nector.
(15) Disconnect the radio speaker wire connector.
(16) Disconnect wiring harness clips from trim
panel.
(17) Disconnect the courtesy lamp, if equipped.
(18) Remove trim panel from vehicle.
Fig. 15 FRONT DOOR TRIM PANEL - TYPICAL
1 - REMOTE BEZEL
2 - I/P INTERFACE
3 - SCREWS
4 - SPEAKER GRILLE
5 - PULL CUP

INSTALLATION

(1) Place door trim panel in position.
(2) Install wire harness clips into door trim panel.
(3) Connect the courtesy lamp, if equipped.
Fig. 16 INNER FRONT DOOR TRIM PANEL -
1 - POWER MIRROR SW.
2 - POWER DOOR LOCK SWITCH
3 - RETAINER CLIPS
4 - COURTESY LAMP
5 - POWER WINDOW SWITCH
(4) Connect the radio speaker wire connector.
(5) Connect the power window switch wire connec-
tor.
(6) Connect the power door lock switch wire con-
nector.
(7) Connect the power mirror switch wire connec-
tor.
(8) Connect the linkage to the handle assembly.
(9) Hook door trim panel over the sheet metal
flange.
(10) Insert the forward four way alignment guide
into position. Insert the rearward two way alignment
guide into position.
(11) Engage rear retaining clips to attach door
trim panel to inner sheet metal panel, up to three
ratchet clicks.
(12) Install three screws in the speaker area.
(13) Install two screws in the instrument panel
interface area.
(14) Install screw in the remote bezel, and close
trim plug.
(15) Install screw in pull cup, and close trim plug.
(16) Install three screws to the bottom of the door.
Tighten all screws to 1.3 to 1.9 N·m (12 to 17 in. lbs.)
torque.
(17) Place speaker grille in position on trim panel.
TYPICAL
LH