Chrysler 2004 Concorde Service Manual page 1159

LH
BUSHING - INNER TIE ROD (Continued)
(4) Remove the wiper module cover and cowl cover
from the vehicle (Fig. 52).
Fig. 52 Wiper Module And Cowl Cover
1 - COWL COVER
2 - WIPER MODULE COVER
(5) Remove the eight bolts attaching the cowl rein-
forcement to the strut towers and the one bolt
attaching the wiper module to the reinforcement
(Fig. 53). Remove the reinforcement from the vehicle.
Fig. 53 Reinforcement Attachment To Vehicle
1 - RIGHT STRUT TOWER
2 - WIPER MODULE
3 - LEFT STRUT TOWER
4 - ATTACHING BOLTS
5 - ATTACHING BOLT
6 - REINFORCEMENT
7 - ATTACHING BOLTS
(6) Remove the in-line resonator and inlet hose
from the throttle body and air let hose coming from
the lid of the air cleaner housing (Fig. 54).
(7) Raise the vehicle on a frame contact hoist until
the front tires of the vehicle are just off the floor. See
Hoisting in Lubrication And Maintenance.
(8) Remove front wheel and tire assembly from
side requiring repair (both sides are recommended).
(9) Remove the nut attaching the outer tie rod end
to the steering arm on the strut (Fig. 55).
Fig. 54 In-Line Resonator And Air Inlet Hose
1 - AIR INLET HOSE
2 - THROTTLE BODY
3 - AIR INLET HOSE
4 - AIR CLEANER HOUSING LID
5 - RESONATOR
6 - IN-LINE RESONATOR
Fig. 55 Tie Rod End Attachment To Strut
1 - TIE ROD END
2 - STEERING ARM
3 - STRUT
4 - NUT
GEAR 19 - 53