Ethernet Interface Parameters; Management Parameters; Ip Access Table Parameters; Access Control Parameters - Proxim ORiNOCO AP-2500 User Manual

Using the Command Line Interface

Ethernet Interface Parameters

Name
Ethernet Interface
Speed
MAC Address

Management Parameters

IP Access Table Parameters

When creating table entries, you may either specify the argument name followed by argument value or simply entering
the argument value. When only the argument value is specified, then enter the values in the order depicted by the
following table. CLI applies default values to the omitted arguments. Due to the nature of the information, the only
argument that can be omitted is the "comment" argument.
Name
IP Access Table
Table Index
IP Address
IP Mask
Comment (optional)
Status (optional)

Access Control Parameters

Name
Access Control
Access Control On
Access Control Table
Access Control Table
Index
Access Control Range
Starting IP Address
Access Control Range
Starting IP Address
Access Control IP Table
Entry Status
NOTE
Both the IP Access Table Parameters and the Access Control Parameters determine which IP addresses are
allowed to manage the AP over the Ethernet interface.
Type Values
Group N/A
Integer 10halfduplex
10fullduplex
10autoduplex
100halfduplex
100fullduplex
autohalfduplex
autoautoduplex (default)
PhyAddress N/A
Type Values
Table N/A
Integer User Defined
IpAddress User Defined
IpAddress User Defined
DisplayString User Defined
Integer enable
disable
delete
Type Values
Group N/A
Integer disable (0)
enable (1)
Table N/A
Integer N/A
IpAddress User Defined
IpAddress User Defined
RowStatus active (1),
notInService (2),
notReady (3),
createAndGo (4),
createAndWait (5),
destroy (6)
Access CLI Parameter
R ethernet
RW etherspeed
R ethermacaddr
Access CLI Parameter
R mgmtipaccesstbl
N/A index
RW ipaddr
RW ipmask
RW cmt
RW status
Access CLI Parameter
R accessctl
RW accessControlOn
RW acIpRangeTable
R acIpRangeIndex
RW acIpRangeStartAddress
RW acIpRangeEndAddress
RW acIpRangeEntryStatus
212