Sun Blade 1000 And Sun Blade 2000 Ultrasparc Iii Cu Cpu Module Installation Guide; Preparing For Installation; Powering Off The Workstation - Sun Microsystems Sun Blade 1000 Module Installation Manual

Sun Blade 1000 and Sun Blade 2000
UltraSPARC III Cu CPU Module
Installation Guide
To install an UltraSPARC III Cu CPU module(s) in a Sun Blade 1000 or Sun Blade
2000 workstation, perform the following installation procedure.
Note – To install an UltraSPARC III 600, 750, or 900 MHz non Cu CPU module in a
Sun Blade 1000 workstation, see the "Sun Blade 1000 UltraSPARC III Module
Installation Instructions", 816-0416-11.

Preparing for Installation

This section describes how to:
Power off the workstation
Remove the access panel
Attach an antistatic wrist strap
Note – If you are returning a used CPU module to Sun Microsystems, return the
used CPU module in the shipping box and packing materials that came with your
new or replacement CPU module.

Powering Off the Workstation

Caution – Prior to turning off power to the workstation, save, back up, and close
any open files. Notify any affected users that you are powering off your workstation.
1. To power off the workstation:
a. If the Solaris OS is running in a windowing environment:
i. Press and release the front panel power switch (see
4 Sun Blade 1000 and Sun Blade 2000 UltraSPARC
automatically shut down all programs and the operating system, and to
power off the workstation.
TM
III Cu Module Installation Guide • January 2002
) to
FIGURE 2