Stator Assembly; Flywheel Assembly - Husqvarna TC449 Workshop Manual

H01921
H01870
1 edition (08-2010) _Rev. 11-2010
st
ENGINE DISASSEMBLY/REASSEMBLY

Stator assembly

• Clean screw (1) and (5) threaded holes.
• Position stator (6).
• Tighten screws (5).
Tightening torque figures
Stator onto engine left crankcase cover
M5 x 20, Microincapsulated
screw replacement
• Apply a layer of sealant onto rubber sheath (2) sealing surfaces.
Consumables
3 - Bond 1209
• Position retaining plate (4), and pulse transducer (3).
• Insert rubber sleeve (2)
• Tighten screws (1).
Tightening torque figures
Pulse transducer onto engine left crankcase cover
M5 x 12 - 10.9, Microincapsulated
screw replacement

Flywheel assembly

• Clean flywheel and crankshaft cone, as well as thread.
• Apply a thin layer of sealant onto flywheel cone.
Consumables
Loctite 638
• Fit flywheel onto crankshaft.
>> Tab and groove are aligned.
• Fit nut (1).
Tightening torque figures
Flywheel onto crankshaft
Collar nut, M14 x 1 Replace
microincapsulated screw nut
F1.21
6 Nm
Surface sealer
6 Nm
Sealant
90 Nm