Turning Indicator Bulb Replacement (Te - Smr); Tail Light Replacement (Te - Smr) - Husqvarna TC449 Workshop Manual

2
3
1 edition (08-2010)_Rev. 11-2010
st
ELECTRICAL SYSTEM

Turning indicator bulb replacement (TE - SMR)

- Loosen screw (1) using a Phillips screwdriver;
1
H06320
- remove lens (2) and replace bulb (3) pushing it inside, and turning it to remove
it;
Once the bulb has been replaced, reverse the above procedure to reassem-
ble.
(12V 6W bulb)
H06321
1

Tail light replacement (TE - SMR)

Remove the tail light as follows:
- Loosen the two screws (1) under the rear mudguard.
H06322
3
- Extract the tail light (2) and disconnect the connector (3).
Once the bulb has been replaced, reverse the above procedure to reassem-
ble.
2
H06323
Be careful not to overtighten the screws.
M.37