Instructions For Clamping In The Vice - Husqvarna TC449 Workshop Manual

1 edition (08-2010) _Rev. 11-2010
st
FRONT SUSPENSION

Instructions for clamping in the vice

For some maintenance procedures you may have to use the vice to clamp some
components of the fork.
The incorrect use of the vice can cause irreparable damage to the fork.
Scrupulously follow the instructions below:
• Limit the use of the vice to those operations where the use of the same is
absolutely necessary;
• Use a vice with padded jaws;
• Avoid over tightening the vice;
• Avoid clamping parts of the fork where even slight ovalization could damage
the part;
The figure shows the zones recommended for fixing the fork in the vice.
A - Wheel axle clamp
B - Slider in the steering crown fixing zone
C - Top part of pumping element rod above the seat of the spring guide stop
ring.
D - Bottom valve spanner seizing
I.31