Husqvarna TC449 Workshop Manual page 254

FRONT SUSPENSION
• Push the pre- assembled pumping element ( 23 ) until it is in contact with
the stanchion tube ( 5 ).
• Tighten the bottom valve by hand.
• Insert the R5081AA tooling inside the fork leg in a way that you can block
the body rotation; to do so, the slot obtained at the tooling bottom edge must
be perfectly inserted into the body hexagon.
In the tooling upper part there are two opposite holes where you can
insert an axle to make blocking easier. However, the tooling must not
2 3
be rotated in any case, but only used to hold the fork leg inner parts.
5
• Using a 21 mm tube wrench tighten the bottom valve ( 41 ) up to the required
torque (see Table 1 - Tightening Torques).
4 1
I.44
1 edition (08-2010) _Rev. 11-2010
st