Enrolling Devices To A Working System Configuration Via Led Keyboard - Teletek electronics ECLIPSE 8 Installation Manual

Eclipse 8/ 32 Series - Installation Manual
The following device types are supported from ECLIPSE Series:
Device
MAIN
The main PCB of the control panel
LED Keyboard LED 16/ 32
LCD Keyboard LCD 32/ 32S
ZEXP Zone expander
PEXP PGM expander
PRX
Proximity card reader
WEXP Wireless expander
LED8
Keyboard LED 8
* Eclipse 8: Up to 2 devices can be enrolled to the system bus: 2 keyboards, 2 proximity card readers or 1
keyboard and 1 proximity card reader.
** Eclipse 32: Up to 31 devices can be enrolled to the system bus irrespective of their type.
NOTE: It is not necessary to enroll the built-in proximity reader in keyboards LED 32, LCD 32 and LCD 32S.
5. Press ENTER button of the used for programming keyboard. The keyboard will confirm the end of the
successful enrollment procedure with sound signal.
6. The new enrolled device is in normal operation mode and ready for further programming and configuration.
Digit Button
0 0
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 8
9 9

5.3. Enrolling Devices to a working system configuration via LED keyboard

1. Enter engineer code (7777 by default) – zone numbers 13, 14, 15 and 16 are lighting on. (For LED 8 – 1, 2,
3 and 4).
2. Enter ADDRESS 8020 and press BYPASS button several times until you reach a free address in the system
– zone numbers from 1 to 16 are lighting on. (For LED 8 – button "0" is lighting on).
3. Press the ENTER button (for a keyboard) or the address button (for module, proxy reader or other) of the
device you want to enroll to the system configuration.
4. After successful enrollment to the control panel, the screen displays a lighting on zone number according the
type of the enrolled device (for LED 8 a lighting button):
Number
1 The main PCB of the control panel
2 Keyboard LCD 32/ 32S
3 Keyboard LED 16/ 32
4 Zone expander
5 PGM expander
6 Proximity card reader
7 Wireless expander
8
Keyboard LED 8
* Eclipse 8: Up to 2 devices can be enrolled to the system bus: 2 keyboards, 2 proximity card readers or 1
keyboard and 1 proximity card reader.
** Eclipse 32: Up to 31 devices can be enrolled to the system bus irrespective of their type.
NOTE: It is not necessary to enroll the built-in proximity reader in keyboards LED 32, LCD 32 and LCD 32S.
Description
Button
Letter
Combination
A
/ + 0
B
/ + 1
C
/ + 2
D
/ + 3
E
/ + 4
F
/ + 5
Description
ECLIPSE 8* ECLIPSE 32**








* Note: Other way for enrolling of a new device is to enter its
unique ID number directly at a free address as use the digit
buttons and some button combinations – see the table below.
The unique ID number is provided from the manufacturer with a
sticker on the backside of the PCB of the device.
The button
is used in the previous design of the keyboard and
has the same functionality.
ECLIPSE 8* ECLIPSE 32**








26















