Connecting Fire Lines - Teletek electronics ECLIPSE 8 Installation Manual

Eclipse 8/ 32 Series - Installation Manual

2.3.4 Connecting Fire Lines

Fire detectors can be connected to every zone set as Fire type zone.
For ECLIPSE 8 are possible to realize only 4-wire connections of 12V alarm fire base with one or two balancing
resistors.
For ECLIPSE 32 are possible to realize 4-wire connections of 12V alarm fire base with one or two balancing resistors
and also connection of two fire detectors to a doubling zone. PGM 4 has a special functionality in ECLIPSE 32 control
panel. It can be programmed to operate as Fire zone with realizing of 2-wire connection of standard 24V fire alarm
base.
Fire
detector
base
Fire
detector
base
*
Fire
detector
base 1
Figure 10. Connecting of Fire detectors
A) Connecting a fire detector with one balancing
resistor
The PGM 1 must be programmed as Fire Reset
and the active status must be +12V.
The PGM 1 Fire reset option for activation is
programmed at address 3013 – event 61.
The Zone type is programmed at address 2xx1,
where "xx" is the zone number.
B) Connecting a fire detector with two balancing
resistors
The PGM 1 must be programmed as Fire Reset
and the active status must be +12V.
The PGM 1 Fire reset option for activation is
programmed at address 3013 – event 61.
The Zone type is programmed at address 2xx1,
where "xx" is the zone number.
C) Connecting of two fire alarm detectors to a
doubling zone
The PGM 1 must be programmed as Fire Reset
and the active status must be +12V.
The PGM 1 Fire reset option for activation is
Fire
programmed at address 3013 – event 61.
detector
The Zone type is programmed at address 2xx1,
base 2
where "xx" is the zone number.
* Note: You can use also two 510Ohm resistors
(by one for every fire detector), instead one 1K
resistor.
D) Realization of 2-wre connection of standard
B24 fire bases to PGM 4, programmed as Fire
Zone at address 3000 in ECLIPSE 32 control
panel.
14