Eclipse 8/ 32 Series - Installation Manual
2.4.2 Supported Keyboards
Summary for ECLIPSE Series Keyboards:
Keyboard
Display
LED 8
LED 16
LED 32
LCD 32
LCD 32S
LED 8
LED 16
LED 8 and LED 16
Description of the keyboard rear panel elements:
1. Mounting holes
2. Main opening for cable running
3. Tamper plate. Fix the plate with a screw to the mounting surface. In case of unauthorized attempt for
demounting the keyboard the tamper plate will break out and release the tamper-switch on the keyboard's PCB.
4. Special cable channels on the back side of the rear panel.
5. Lever holder.
Keyboard terminals:
RED, GRN, YEL, BLK - System bus interface for connection to control panel
Zone – Independent full functional keyboard zone with freely programmable parameters. It can be used as additional
zone to control panel and must be attached to a zone number at address 2xx0 (xx is number from 09 to 32) with the
respective number of the device.
GND – Common ground
PGM (LCD 32 and LCD 32 Sensitive) – Programmable output, 100mA, OC type
Areas
Zones
LED
1
8
LED
2/3
16
LED
8
32
LCD
8
32
LCD
8
32
LED 32
Figure 13. Front panels of ECLIPSE Series Keyboards
LED 32 and LCD 32
Figure 14. Rear panels of ECLIPSE Series Keyboards
Proximity card reader
(option)
(option)
LCD 32
16
1 x AUX PGM
LCD 32 Sensitive
LCD 32 Sensitive