Supported Expander Modules - Teletek electronics ECLIPSE 8 Installation Manual

Eclipse 8/ 32 Series - Installation Manual
BYPASS
TROUBLE
MEMORY
Scroll
arrows
Digit
0 - 9
Buttons

2.4.3 Supported Expander modules

Summary for ECLIPSE Series Expander modules:
Module Description
ZONE 8 8-Zone expander
PGM 8 8-PGM expander
The ECLIPSE Series expander modules are connected to the system bus.
Every module is available in two variants:
a) PCB with power supply from the control panel – mounted under the main PCB in the control panel box or in
small universal plastic box;
b) PCB with own power supply, for mounting in big box with transformer unit and 220V terminal.

Installation in the box of ECLIPSE 32 control panel
Remove the PCB of the ECLIPSE 32 control panel – the PCB is secured with two clips from both sides.
Mount the expander module PCB to the bottom of the box:
1. Fix the upper side of the PCB into the holders as shown on the Figure 15.
2. The pins of the bottom must fit in the PCB openings.
3. Press the PCB of the expander downwards to secure with the clips.
4. Mount back the PCB of the ECLIPSE 32 control panel above the expander – fix it into the upper holders (4)
and press down to secure in the side clips (5).
5. Connect the 8-Zone Expander to the ECLIPSE 32 serial system bus as observe the polarity – see Figures
11 and 12.
Figure 15. Example for mounting of expander module in the ECLIPSE 32 panel box
Bypassing zones. The button lights on permanently if there are bypassed zones in the
system. The button is blinking during the bypassed zones review.
The button has a special function in engineer programming – canceling the entered
settings and moves forward as the current index number is increased with +1, option 0.
Reviewing the system troubles. The button lights on permanently if there are system
problems. The button is blinking during the system troubles review.
Reviewing the memory events log file. The button lights on permanently if there are
memory events. The button is blinking during the memory events review. The button has a
special function in text entering mode – entering of special symbols.
Arrows for moving the cursor on the left and on the right in programming mode.
Digital buttons for entering parameters, codes, etc.
ECLIPSE 8


ECLIPSE 32


18