Operation Modes; Review Of Alarm Events; Review Of Fault Events - Teletek electronics SIMPO Operation And Maintenance Manual

SIMPO Addressable Fire Alarm Panel – Maintenance Menus

2. OPERATION MODES

The regular users (access level 1) can review the current status of the panel for Alarm events, Troubles, etc, without
entering special access code for operation. The regular users can silence the internal buzzer and send manually
evacuation signal in those cases, when the fire alarm is received from a device.
Operation Mode
ALARMS Viewing the Alarms Messages in the system.
FAULTS Viewing the Faults Messages in the system.
DISABLED Viewing the active disablements in the system.
TESTS Viewing the running tests in the system.
WARNINGS Viewing the Warnings Messages in the system.
Silence buzzer Deactivating Internal Buzzer.
Activating Evacuation alarm signal; the sounders will activate immediately overriding all introduced
Evacuation
delays*.
* Just for those cases, when the fire alarm signal is received from a device.
Test General test for operability of all LEDs and internal buzzer.

2.1. Review of Alarm Events

The messages for alarm events are displayed with the highest priority in the system. In case of alarm in the system, the
panel will show a list with active alarms at the moment, and ALARMS mode is blinking together with the number of the
first alarm message. Over the button (1) is displayed the total number of the active alarms. The LED 'General Fire' lights
on together with the number of the zone in alarm. The panel is signalling with continuous sound signal, which can be
stopped with pressing the 'Silence buzzer' button. The activated sounders could be stopped after entering access level 2
(Maintenance mode) and pressing the 'Silence sounders' button.
Example:
The User can review also some additional information for every of the alarm events. For this, select the number of the
alarm message using up/ down arrow buttons (the number of the selected event is blinking) and press ENTER button.
On the screen is displayed information for the loop number and the address of the activated device reported the alarm
event. At the bottom of the screen is displayed the day and time of occurring of the respective event. Note that the
additional information is different according the type of the alarm event. To exit the review alarm events mode, press
CANCEL button.

2.2. Review of Fault Events

The messages for fault events are displayed with high priority. If no alarm events are present, and there are active faults
in the system, the FAULTS mode is blinking together with the number of the first fault event. The LED 'General Fault'
lights on. The faults messages are cleared automatically after the fault condition is restored.
Example:
The User can review also some additional information for every of the fault events. For this, select the number of the
fault message using up/ down arrow buttons (the number of the selected event is blinking) and press ENTER button.
In case, there are active alarms in the system, but you want to review the fault messages, press button (2) – FAULTS
mode. The present faults in the system are displayed with serial numbers. The reviewing is the same as described in
Description
6