Activation Of An Alarm And A Fault - SDMO R 340 U User And Maintenance Manual

6.2.4.3.

Activation of an alarm and a fault

The appearance of an alarm and a fault causes:
The yellow and red LEDs to flash
the related screen to be displayed (example below)
FAULTS 1/2
FAULT
Emergency Stop
25/12/05 15:30
Esc=RESET
The faults list can be accessed by pressing OK (of the scrolling and selection wheel) (examples below)
FAULTS
FAULT 25/12/05 15:30
Emergency Stop
ALARM 25/12/05 15:30
Low Fuel Level
OK=HELP
Check:
- Emerg. Stop Pos.
- Connector(s)
If the alarm is no longer active, it is reset automatically (cause disappears).
Press Esc to reset a fault:
reset acknowledged if the cause of the fault has been removed
-
reset not performed if the cause of the fault is still present.
-
OK=LIST
1/2
Esc
HELP
Esc
If several faults are present, the number of faults is displayed at
the top of the screen.
Press Esc to return to the previous screen.
Press OK to go to the HELP screen (help on the highlighted
fault)
Use the scrolling and selection wheel to scroll through the list of
faults.
50/285