Installation; Unloading; Safety During Unloading; Instructions For Unloading - SDMO R 340 U User And Maintenance Manual

RECOMMENDATIONS FOR USE:
Compatible with the original fluid.
It is recommended that the cooling system is completely drained when replacing the fluid.
SPECIFICATIONS
Density at 20°C
pH
Alkalinity reserve
Boiling point
Freezing point:
Glassware corrosion :
(test with antifreeze)
- Copper
- Weld
- Brass
- Steel
- Cast iron
- Cast aluminium
Corrosion on warm plate
(test with antifreeze)

3. Installation

3.1.

Unloading

3.1.1 Safety during unloading

To unload electrical generating sets from their transport supports under optimum safety and efficiency conditions, you need to
ensure that the following points are observed:
- Lifting machinery or equipment appropriate to the work required.
- Slings positioned in the eyes provided for this operation or lifting arms resting fully underneath the chassis cross members.
- Ground able to take the load of the set and the lifting machinery without stress (otherwise lay down beams of sufficient strength
and stability).
- Set put down as close as possible to its point of use or transportation, in a clear area with free access.
Example of equipment to be used:
crane, slings, cross bar, safety catch, shackles.
Fork lift truck.

3.1.2 Instructions for unloading

3.1.2.1.

Slings

Attach the lifting vehicle slings to the rings on the generating set designed for this procedure. Hang the slings carefully.
Check that the slings are correctly attached and the equipment is solid.
Lift the generating set carefully.
Direct and stabilise the set towards the chosen position.
Carefully set down the equipment while continuing to position it.
Release the slings, then detach and remove the lifting rings.
UNITS SPECIFIED VALUES
kg/m 3
1,059 +/- 3
pH
ml
°C
°C
mg/test piece
mg/(cm²week)
21/285
TRIAL
METHODS
R 15-602-1
NF T 78-103
7.5 to 8.5
NF T 78-101
>=10
R 15-602-4
105 +/- 2
NF T 78-102
-26 +/- 2
R 15-602-7
+/- 2.6
+/- 0.5
+/- 2.3
+/- 1.6
+/- 0.8
+/- 1.0
R 15-602-8
+/- 0.17