Dismantling, Reassembly - SDMO R 340 U User And Maintenance Manual

LEROY-SOMER

4.6 - Dismantling, reassembly

(see sections 5.4.1. & 5.4.2.)
WARNING
During the warranty
operation should only be carried out in
an LEROY-SOMER approved workshop
or in our factory, otherwise the warranty
may be invalidated.
Whilst being handled, the machine
should remain horizontal (rotor not
locked in position). Check how much the
machine weighs (see 4.8.3) before
choosing the lifting method.
4.6.1 - Tools required
To fully dismantle the machine, we
recommend using the tools listed below:
- 1 ratchet spanner + extension
- 1 torque wrench
- 1 set of flat spanners: 8 mm, 10 mm, 18 mm
- 1 socket set: 8, 10, 13, 16, 18, 21, 24, 30 mm
- 1 socket with male ferrule: 5 mm
- 1 puller
4.6.2 -Screw tightening torque
See section 5.4.
4.6.3 - Access to diodes
- Open the air intake grille (51).
- Disconnect the diodes.
- Check the 6 diodes, change the diode
bridges if necessary.
14
Installation and maintenance
LSA 46.2 - 4 POLES
ALTERNATORS
period, this
226/285
4.6.4 - Access to connections and the
regulation system
Access directly by removing the top of the
cover (48) or the AVR access door (466).
4.6.5 - Replacing the NDE bearing
- Remove the box lid (48) and the NDE panel
(365) and remove the 2 screws from the part
(122).
- Disconnect the stator outputs (T1 to T12).
- Disconnect the auxiliary winding wires
AREP (X1,X2,Z1,Z2).
- Disconnect the exciter wires (5+,6-).
- Remove the air inlet louvre (51).
If using a single-bearing or double-bearing
machine with the regreasable bearing
option:
- Remove the bearing (78) thrust screws
(72).
- Remove all 4 screws (37).
- Remove the shield (36).
- Take out the antifriction bearing (70) using
a puller with a central screw (see drawing
below).
- Fit the new antifriction bearing onto the
shaft after heating it by induction to
approximately 80 °C.
- Mount the new preloading (wavy) washer
(79) + the new "O" ring seal (349) in the
shield (36) and coat the bearing seat with
adhesive paste (see After Sales Service).
If using a single-bearing or double-bearing
machine with the regreasable bearing
option:
- Screw a threaded rod into the thrust
bearing (78).
- Refit the end shield on the machine using
a dowel and nut in the shaft extension (see
drawing).
3856 en - 2011.01/ h