Installation Workflow - Nomadix Universal subscriber gateway User Manual

U S
NIVERSAL UBSCRIBER

Installation Workflow

This flowchart illustrates the steps that are required to install and configure the
Universal Subscriber Gateway successfully. Review the installation workflow before
attempting to install the USG on the customer's network.
Place the USG on a flat and stable work surface and connect the power cord.
Connect the USG to a "live" network. Use the DB9 male-to-female serial
cable (6 ft. length) between the USG's serial port and your computer.
Power up your computer and turn on the USG.
Start a HyperTerminal session to communicate with the USG via the serial port.
When prompted, configure your USG's IP, DNS, and Location
settings. The USG will then prompt you to reboot the system.
When prompted, accept to the Nomadix End User License Agreement (EULA). You must
accept the EULA before the USG can connect with the Nomadix License Key Server. When
the key is successfully received from the server, your USG will reboot. You can now power
down and connect the USG to the customer's network.
Network
Power up the USG and log in via a Telnet session or the Web Management Interface.
Set the basic configuration parameters for subscribers.
The Universal Subscriber Gateway is now ready for administrators to add,
Export your configuration settings to an archive file.
Installing the USG
G ™
ATEWAY
Log in to the Command Line Interface.
Connect the USG to the customer's network.
delete, or change unique subscriber profiles.
33