Nomadix Universal subscriber gateway User Manual page 75

U S
NIVERSAL UBSCRIBER
Assign a valid
6. DHCP Server IP
Relay Agent IP
The DHCP Relay Agent allows the USG to request a specific range of IP
addresses from different IP pools from the DHCP Server. Leaving these fields
blank forces the system to use the IP pool that contains IP addresses that are on
the same subnet as the USG.
"
You must disable the DHCP server before enabling the DHCP relay.
Both features cannot be enabled concurrently (unless the IP Upsell
feature is enabled).
#
If the DHCP Relay Agent IP address is set for an address that is already
used or the IP address of the server, the other system will get an IP
conflict and will not have internet access.
After assigning the IP address for the DHCP Relay and the DHCP Relay Agent,
7.
you must reboot the system for the new settings to take effect. Click the check
box for
Reboot after changes are saved?
system, or click on the
previous state.
When the system restarts, the DHCP relay functionality is enabled and
configured. Skip the remaining steps in this procedure and go to
DNS Options {DNS}" on page 72
You are at this step because you want the USG to act as its own DHCP Server
8.
(you did not enable the DHCP Relay). If the
must enable it now.
Select
9. Public Pool
Enter a valid
10. DHCP Server IP
Enter the
11. DHCP Server Netmask
Enter the starting and ending IP addresses for the DHCP address pool you want
12.
to use:
DHCP Pool Start IP
! ! ! !
DHCP Pool Stop IP
! ! ! !
Enter the
13. DHCP Lease Minutes
If you made any changes to the settings on this screen, you must click the check
14.
box for
Reboot after changes are saved?
System Administration
G ™
ATEWAY
address (the default is 0.0.0.0) and a valid
address.
button if you want to reset all the values to their
Reset
.
or , as required.
Private Pool
address for the DHCP server.
.
.
to save your changes and reboot the
"Managing the
is not enabled, you
DHCP Server
(the USG must be rebooted).
DHCP
71