Using Dhcp (Ipv4) - HP Jetdirect J7974E Administrator's Manual

Table 3-2 TFTP Configuration File Parameters (continued)
For AUTO (default), the print server uses auto-negotiation to configure itself with the highest link speed and communication
mode allowed. If auto-negotiation fails, either 100TX HALF or 10TX HALF is set depending on the detected link speed of
the hub/switch port. (A 1000T half-duplex selection is not supported.)
upgrade:
To configure one or more Jetdirect print servers with the name and location of a firmware upgrade file.
CAUTION
than the currently installed version. The print server will attempt to upgrade when the upgrade file contains a
higher version than the installed version.
The command format is:
upgrade: <TFTP server IP> <Version> <Product Number> <Filename>
where,
<TFTP Server IP> is the IP address of the TFTP server,
<Version> specifies the firmware version of the upgrade file,
<Product Number> specifies and must match the product number of the print server,
<Filename> is the path and filename of the firmware upgrade file.
status-page-lang:
Specifies the page description language (PDL) that the print server will use to send the Jetdirect configuration/status page
to the printer.
●
Auto (default): The PDL is auto-detected when the print server is powered on or after a cold-reset.
● PCL: Hewlett-Packard Printer Control Language
●
ASCII: Standard ascii characters
● HPGL2: Hewlett-Packard Graphics Language (v2)
●
PS: PostScript language
Support
support-name:
Typically used to identify the name of a person to contact for support of this device.
support-number:
Typically used to specify a phone number or extension to call for support of this device.
support-url:
A Web URL for product information on this device over the Internet or an intranet.
tech-support-url:
A Web URL for technical support over the Internet or an intranet.

Using DHCP (IPv4)

Dynamic Host Configuration Protocol (DHCP, RFC 2131/2132) is one of several auto configuration
mechanisms that the HP Jetdirect print server uses. If you have a DHCP server on your network, the
HP Jetdirect print server automatically obtains its IP address from that server and registers its name
ENWW
Ensure that command parameters are properly entered and that the upgrade file is a higher version
(or support-contact:)
IPv4 Configuration 35