HP Jetdirect J7974E Administrator's Manual page 63

Hp jetdirect print servers
Table of Contents

Advertisement

Table 3-3
Telnet Commands and Parameters (continued)
xml-services-conf
ws-discovery-conf
1000t-ms-conf
1000t-pause-conf
link-type
Support
Web JetAdmin URL
ENWW
For Ethernet print servers, the LAA address must start with hexadecimal X2, X6, XA, or
XE, where X is any hexadecimal digit 0 through F.
The default address is the factory-assigned address.
Enable or disable access by HP Web service applications to XML-based data on the HP
Jetdirect print server.
1: (Default) Enable
0: Disable
Enable or disable the Microsoft Web Services Dynamic Discovery (WS Discovery)
protocols on the print server.
1: (Default) Enable
0: Disable
Use this command to configure the print server as a master or slave device on a 1000T
network.
AUTO or 0: (Default) A master/slave configuration is automatically sensed and assigned.
MASTER or 1: The device is configured as a 1000T master device.
SLAVE or 2: The device is configured as a 1000T slave device.
This command is used for flow control of inbound and outbound data.
OFF or 0: (Default) Flow control is disabled.
AUTO or 1: Flow control is configured through auto-negotiation with the network switch.
RCV or 2: Flow control is enabled only for data received from the network.
TRANS or 3: Flow control is enabled only for data transmitted to the network.
TXRX or 4: Flow control is enabled for both received and transmit data.
(For wired 10/100/1000T Ethernet) Sets the print server's link speed (10, 100, 1000 Mbps)
and communication mode (Full- or Half-Duplex). The available link-speed selections
depend on the print server model. The selections that may be displayed are listed below.
CAUTION
If you change the link setting, network communications with the print
server and network device may be lost.
AUTO (default):
1000FULL: 1000 Mbps, full-duplex operation.
100AUTO: Limits auto-negotiation to a maximum link speed of 100 Mbps.
100FULL: 100 Mbps, full-duplex operation.
100HALF: 100 Mbps, half-duplex operation.
10FULL: 10 Mbps, Full-duplex operation.
10HALF: 10 Mbps, half-duplex operation.
(Read-only parameter) If HP Web Jetadmin discovers this device, the URL to access HP
Web Jetadmin will be specified.
IPv4 Configuration
53

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Jetdirect J7974E and is the answer not in the manual?

Table of Contents