Restore Defaults; Authorization; Admin. Account - HP Jetdirect J7974E Administrator's Manual

Table 4-14 Wizard Security Levels (continued)
Security Level

Restore Defaults

This page is used to restore security configuration settings to factory defaults. The default settings
displayed depend on the features supported by the print server.
Only the security settings listed are restored to factory defaults, other configuration settings are not
affected.

Authorization

The Authorization page provides tabs that allow you to control access to the device, as well as to device
configuration and management features. In addition, you may configure certificates for client and server
authentication.

Admin. Account

Use this page to set an administrator password for controlled access to Jetdirect configuration and status
information. The administrator password is shared by Jetdirect configuration tools, such as the
embedded Web server, Telnet, and HP Web Jetadmin. In addition, for selected printers, the password
is shared with the printer (see
If a password is set and you attempt to access Jetdirect print server settings, you will be prompted for
a user name and this password before you are allowed access.
NOTE
administrator password may be cleared by applying blank entries, or by a cold reset of the print
server to factory-default settings.
ENWW
Description
NOTE
the Admin. Account page below.
The Web Mgmt. page (for full-featured print servers only) is used for HTTPS (secure
HTTP) configuration, including certificates and encryption levels.
The Management Tools page allows configuration of management protocols that are not
secure (such as RCFG, Telnet and FTP firmware updates).
SNMP Configuration pages are used to configure specific SNMP settings:
●
Enable SNMPv1/v2: Enable this option to allow management software that use
SNMP v1/v2. If selected the SNMPv1/v2 Configuration page is displayed to configure
SNMP community names.
● Enable SNMPv3: (Full-featured print servers only) Enable this option to create an
SNMP v3 account. Creating an SNMP v3 account is not recommended if you manage
devices using HP Web Jetadmin. See SNMP.
The Access Control page is used to set up an Access Control List, if desired to control
host access to the device.
The Print Protocols and Services page is used to enable or disable network printing,
print services, and device discovery protocols that may affect security.
The Configuration Review page displays all the current settings that may affect security.
Click Finish to set your basic security selections.
Printer Password Synchronization
If you have logged into the print server using an administrator password, the
To clear the Administrator Password, enter blank entries, or refer to
below).
Networking Tab 83