HP Jetdirect J7974E Administrator's Manual page 144

Table 8-12 Error Messages (continued)
Error Code and Message
4A CF ERR - UNKNOWN
KEYWORD
4B CF ERR - MISSING
PARAMETER
4C CF ERR - INVALID PARAMETER A line in the TFTP configuration file contained an invalid value for one of the parameters
4D CF ERR - ACCESS LIST
EXCEEDED
4E CF ERR - TRAP LIST
EXCEEDED
4F TFTP REMOTE ERROR
50 TFTP LOCAL ERROR
51 TFTP RETRIES EXCEEDED
52 BAD BOOTP/DHCP REPLY
53 BAD BOOTP TAG SIZE
54 BOOTP/RARP IN PROGRESS
55 BOOTP/DHCP IN PROGRESS
56 DHCP NAK
57 UNABLE TO CONNECT DHCP
SVR
58 POSTSCRIPT MODE NOT
SELECTED
59 INCOMPLETE F/W - MUST
DOWNLOAD
5A TURN PRINTER OFF / ON
5C DHCP BAD REPLY
5D DHCP LEASE DURATION TOO
SHORT
134 Chapter 8 HP Jetdirect Configuration Pages
Description
A TFTP configuration file line contained an unknown keyword.
A line in the TFTP configuration file was missing a required parameter.
on that line.
The TFTP configuration file specified too many access list entries using the "allow:"
keyword.
The TFTP configuration file specified too many trap destination list entries using the
"trap-destination:" keyword.
The TFTP transfer of the configuration file from the host to the HP Jetdirect print server
failed with the remote host sending a TFTP ERROR packet to the print server.
The TFTP transfer of the configuration file from the host to the HP Jetdirect print server
failed with the local print server encountering some form of inactivity timeout, or
excessive retransmissions situation.
The overall retrying of the TFTP transfer of the configuration file from the host to the HP
Jetdirect print server has exceeded a retry limit.
An error was detected in the BOOTP or DHCP reply that the HP Jetdirect print server
received. The reply either had insufficient data in the UDP datagram to contain the
minimum BOOTP/DHCP header of 236 bytes, had an operation field that was not
BOOTPREPLY(0X02), had a header field that did not match the print servers hardware
address, or had a UDP source port that was not the BOOTP/DHCP server port (67/udp).
The tagsize in a vendor-specific field in the BOOTP reply is either 0, or greater than the
remaining number of unprocessed bytes in the vendor-specified area.
The HP Jetdirect print server is currently in the process of obtaining its basic IP
configuration information through BOOTP/RARP.
The HP Jetdirect print server is currently in the process of obtaining its basic IP
configuration information through BOOTP/DHCP, and has not detected any errors.
The HP Jetdirect print server received a negative acknowledgement message from the
DHCP server in response to a configuration request.
The HP Jetdirect print server had received IP parameters from a DHCP server, but
communication with the DHCP server has been lost. Check status of the DHCP server.
If an infinite lease was assigned, the print server will use the IP address of the most
recent DHCP server used, but operation may be degraded until a DHCP server
responds.
The printer does not support AppleTalk or AppleTalk extensions.
Firmware download message. Currently downloading firmware to the HP Jetdirect print
server, or the download did not complete properly.
Firmware download message. Download of firmware is complete. Power off/on the HP
Jetdirect print server.
A bad reply was received from the DHCP server. Check your DHCP server settings for
this print server.
The DHCP lease times for this print server's TCP/IP configuration settings are too short.
Reconfigure the DHCP lease times on the DHCP server.
ENWW