Error Messages - HP Jetdirect J7974E Administrator's Manual

Table 8-11 DLC/LLC Configuration Information
Message
STATUS:

Error Messages

Error codes and messages that may appear in the Status sections of the Jetdirect configuration page
are described in
Table 8-12 Error Messages
Error Code and Message
02 LAN ERROR - INTERNAL
LOOPBACK
03 LAN ERROR - EXTERNAL
LOOPBACK
06 ENCRYPTION REQUIRED
07 LAN ERROR - CONTROLLER
CHIP
07 AUTHENTICATION FAILED
08 LAN ERROR - INFINITE
DEFERRAL
08 AUTHENTICATION IN
PROGRESS
09 LAN ERROR - BABBLE
0A LAN ERROR - NO SQE
ENWW
Description
Indicates the current DLC/LLC protocol status.
READY: Indicates the HP Jetdirect print server is awaiting data.
DISABLED: Indicates that DLC/LLC was manually disabled.
INITIALIZING: Indicates that the print server is registering the node address or name.
An additional status message may also be displayed.
An error code and message is displayed if the print server is not ready. For more
information, see
Table 8-12 Error Messages.
Description
During self-test, the HP Jetdirect print server detected an internal loopback test error.
The print server may be faulty. If the error persists, replace the HP Jetdirect print server.
The HP Jetdirect print server is incorrectly connected to your network or is defective.
Make sure your HP Jetdirect print server is correctly attached to your network. In
addition, check the cabling and connectors.
Encryption is required on this network, but the print server cannot communicate on the
network due to improper encryption settings. Check the encryption settings configured
on the print server.
Check the network connections. If the connections are intact, run the power-on self-test:
turn the printer off, then on again. If the error persists, replace the HP Jetdirect print
server.
The Jetdirect print server could not access the network because of an authentication
error. The error depends on the authentication method used.
Verify the authentication method and settings on the print server.
There is a network congestion problem.
NOTE
occur.
Link-level authentication is in progress.
Check the network connections. If the connections are intact, run the power-on self-test:
turn the printer off, then on again. If the error persists, replace the HP Jetdirect print
server. For replacement instructions, see the hardware installation guide for your print
server.
(Wired Ethernet) Check the network connections. If the connections are intact, run the
power-on self-test: turn the printer off, then on again. If the error persists, replace the
HP Jetdirect print server.
Table 8-12 Error Messages.
If the print server is not connected to the network, this error cannot
HP Jetdirect Configuration Page 129