HP Jetdirect J7974E Administrator's Manual page 62

Table 3-3 Telnet Commands and Parameters (continued)
appletalk
Name
Print Type
Zone
Phase
Status
DLC/LLC
dlc/llc-config
strict-8022
Other
upgrade
laa
52 Chapter 3 TCP/IP Configuration
Enables or disables AppleTalk (EtherTalk) protocol operation on the print server. 0
disables, 1 (default) enables. For example,
appletalk 0 will disable AppleTalk operation
(Read-only parameter) The name of the printer on the AppleTalk network. A number after
the name indicates that there are multiple devices with this name, and this is the Nth
instance of the name.
(Read-only parameter) Specifies the AppleTalk network printer type reported by the
Jetdirect print server. Up to three print types may be reported.
(Read-only parameter) The name of the AppleTalk network zone on which the printer is
located.
(Read-only parameter) AppleTalk phase 2 (P2) is preconfigured on the HP Jetdirect print
server.
(Read-only parameter) Indicates the current AppleTalk configuration status.
READY: Indicates the HP Jetdirect print server is awaiting data.
DISABLED: Indicates that AppleTalk was manually disabled.
INITIALIZING: Indicates that the print server is registering the node address or name. An
additional status message may also be displayed.
Enables or disables DLC/LLC protocol operation on the print server. 0 disables, 1 (default)
enables. For example,
dlc/llc-config 0 will disable DLC/LLC operation.
Controls DLC/LLC protocol interpretation:
0 (default): disables, that is, provides loose interpretation.
1: enables, that is, provides strict interpretation).
To configure one or more Jetdirect print servers with the name and location of a firmware
upgrade file.
CAUTION Ensure that command parameters are properly entered and that the
upgrade file is a higher version than the currently installed version. The print server
will attempt to upgrade when the upgrade file contains a higher version than the
installed version.
The command format is:
upgrade: <TFTP server IP> <Version> <Product Number> <Filename>
where,
<TFTP Server IP> is the IP address of the TFTP server, <Version> specifies the
firmware version of the upgrade file, <Product Number> specifies and must match the
product number of the print server, <Filename> is the path and filename of the firmware
upgrade file.
Specifies a locally administered address (LAA) that replaces the factory-assigned LAN
Hardware (MAC) address. If LAA is used, a user-specified string of exactly 12 hexadecimal
digits must be entered.
ENWW