Security Configuration Page - HP Jetdirect J7974E Administrator's Manual

Table 8-12 Error Messages (continued)
Error Code and Message
5E DHCP LEASE RELEASED
5F WINS REGISTRATION FAILED
61 AUTO IP CONFIGURED
62 DEFAULT IP CONFIGURED
63 AUTO IP IN PROGRESS
64 INVALID PASSWORD
83 DISCONNECTING FROM
SERVER
84 DHCP LEASE TIMERS
ADJUSTED
86 FOR MULTILANGUAGES
UPGRADE AGAIN
F1 TRYING TO CONNECT TO
SERVER
F2 TFTP IN PROGRESS
F3 BOOTP/RARP IN PROGRESS
F4 BOOTP/DHCP IN PROGRESS

Security Configuration Page

An enhanced Security page can be printed from the Jetdirect menu accessed through the printer control
panel. A typical Security page is illustrated below.
ENWW
Description
The lease for DHCP-configured parameters, including the IP address, have been
released through a manual configuration method, such as through the printer's control
panel.
Attempts to register the print server's name on the WINS server failed. Check for
duplicate names, or verify the WINS server configuration.
An IP address could not be retrieved over the network. The print server will default to
an IP address using link-local addressing in the form 169.254.x.x.
An IP address could not be retrieved over the network. The print server will default to a
legacy default IP address 192.0.0.192.
The print server is automatically assigning an IP address using link-local addressing in
the form 169.254.x.x.
An invalid password was specified through TFTP. Verify that the password consists of
a maximum of 16 printable characters.
The server has been shut down because of a configuration change or reset request.
This message automatically clears after a few seconds, unless the printer is offline, is
in an error state, or is servicing another I/O port or another network protocol.
The print server detected a DHCP lease error due to one of the following conditions:
●
Renew time is less than 30 seconds.
● Rebind time is less than 52 seconds.
●
Rebind time is less than, or equal to, the Renew time.
● The lease duration is less than, or equal to, the Rebind time.
When upgrading a supported print server that contains a firmware version prior to X.
24.00, it will be necessary to perform the firmware upgrade again if you want the print
server to support management tools (for example, the embedded Web server) using
non-English languages.
The HP Jetdirect print server is trying to connect to the NetWare server(s). This is a
normal message. Wait until either the connection is established or another status
message appears.
The print server is attempting to use TFTP to obtain TCP/IP configuration settings over
the network.
The print server is attempting to use BootP or RARP to obtain TCP/IP configuration
settings over the network.
The print server is attempting to use BootP or DHCP to obtain TCP/IP configuration
settings over the network.
Security Configuration Page 135