HP Jetdirect J7974E Administrator's Manual page 80

Table 4-7 TCP/IP Config Precedence tab
Item
Configuration Methods
Reset to default scheme
Reinitialize Now
Clear Previous Values and
Reinitialize Now
Apply
Cancel
Example: To set all parameters configured through DHCP to be "Read-only", and to allow manual
configuration only of parameters that are not configured through DHCP, proceed as follows:
1. Power on the print server so that it obtains its DHCP configuration.
2. Change the precedence table to the following:
BOOTP/DHCPv4
DHCPv6
TFTP
Manual
Default
3. Press Clear Previous Values and Reinitialize Now
70 Chapter 4 HP Jetdirect Embedded Web Server (V.34.xx)
Description
Specifies the precedence of the configuration methods used to configure the print
server. The default precedence is indicated below, where manual configuration has the
highest priority.
Manual: Configuration through tools such as the printer control panel, Telnet, embedded
Web server, installation and management software.
TFTP: Configuration through a TFTP file from a TFTP server, typically identified during
a BootP/DHCP configuration.
DHCP/Bootp: Configuration from a BootP or DHCPv4 server.
DHCPv6: Configuration from a DHCPv6 server.
Default: Factory default configuration.
To change the order of the list, select an entry and use the up or down arrows to move
it.
This button resets the precedence table to the default sequence described above.
This button saves the new precedence table, clears the configuration method to its
factory-default setting, and restarts the IP stack.
This button saves the new precedence table, clears the configuration method to its
factory-default setting, clears current TCP/IP parameter settings, and restarts the IP
stack.
The Apply button saves changes to the Configuration Methods precedence table.
Depending on the changes made, you may need to turn the print server Off/On to
implement the change.
The Cancel button cancels your changes to the precedence table.
CAUTION The Cancel button will not affect changes made by the Reinitialize
Now or Clear Previous Values and Reinitialize Now buttons.
ENWW