HP Jetdirect J7974E Administrator's Manual page 55

Table 3-3 Telnet Commands and Parameters (continued)
Config Server
TFTP Server
TFTP Filename
domain-name
pri-dns-svr
sec-dns-svr
pri-wins-svr
sec-wins-svr
TCP/IP Print Options
9100-printing
ftp-printing
ipp-printing
lpd-printing
banner
ipp-job-acct
interlock
mult-tcp-conn
ENWW
assigns 192.168.40.1 as the IP address of the default gateway for the print server.
NOTE If the HP Jetdirect print server is configured by DHCP and you manually
change the subnet mask or the default gateway address, you should manually
change the print server's IP address. This will release the DHCP-assigned
address back to the DHCP IP address pool.
(Read-only parameter) The IP address of the server (such as a BOOTP or DHCP server)
that last configured the IP address on the HP Jetdirect print server.
(Read-only parameter) The IP address of the TFTP server that provided TFTP parameters
to the HP Jetdirect print server.
(Read-only parameter) The path and TFTP filename on the TFTP server. For example,
hpnp/printer1.cfg
The domain name for the device. For example,
domain-name support.hp.com
assigns support.hp.com as the domain name.
The domain name does not include the host name; it is not the Fully Qualified Domain
Name (such as printer1.support.hp.com).
IP address of the primary DNS (Domain Name System) server.
IP address of a secondary DNS server to use if the primary DNS server is unavailable.
The IP address of the primary Windows Internet Naming Service (WINS) server, in dotted
notation.
The IP address of the secondary Windows Internet Naming Service (WINS) server, in
dotted notation.
Enables or disables printing to TCP port 9100 on the print server. 0 disables, 1 (default)
enables.
Enables or disables the ability to print through FTP. 0 disables, 1 (default) enables. (TCP
ports 20, 21)
Enables or disables the ability to print using IPP. 0 disables, 1 (default) enables. (TCP port
631)
Enables or disables the ability to print using LPD. 0 disables, 1 (default) enables.(TCP port
515)
Enables or disables printing an LPD banner page. 0 disables banner pages. 1 (default)
enables banner pages.
Enable or disable job accounting for IPP printing. 0 disables, 1 (default) enables.
Specifies whether an acknowledgement (ACK) on all TCP packets is required before the
printer is allowed to close a Port 9100 print connection. A Port Number and Option value
are specified. For HP embedded print servers, the default Port Number is 1. Option value
0 (default) disables interlock, 1 enables. For example,
"interlock 1 1" specifies port 1, interlock enabled.
(Restrict Multiple Ports) Enables or disables multiple TCP connections. Allows you to
restrict the use of multiple ports.
0 (default): allows multiple connections.
IPv4 Configuration 45